Light refresh
Polish and Recoat
For dull floors with surface scratches. The finish is cleaned, buffed and recoated. It is quick and low dust.
- Hours
- Low dust
- Lower cost
Al Salam Tower, Office 15B, Al Barsha, DubaiEvery day, 8am to 10pm
If your parquet is dull and lightly scratched but the finish has not worn through, it does not need sanding. A deep clean, buff and fresh coat of lacquer or oil brings back the shine and protection in a few hours, with almost no dust.
Starting Price
AED 15*/m²
starting price per square metre
Shine Back
A polish and recoat brings back shine without sanding.
We clean, buff and recoat parquet with minimal dust.
Options
Light refresh
For dull floors with surface scratches. The finish is cleaned, buffed and recoated. It is quick and low dust.
Full restore
For floors worn to bare wood, deep scratches or a colour change. The floor is sanded back and refinished. It takes days.
Process
Dirt, grease and old polish build-up are removed.
The finish is lightly abraded with a buffer to give grip.
A fresh coat of lacquer or maintenance oil is applied.
The floor dries for a few hours before light use.
Recoating before the finish wears through is the best way to protect parquet. It adds a new layer of protection so the timber underneath never gets damaged.
Shop-bought polishes can leave sticky build-up that dulls the floor and stops new finishes bonding. We remove it before recoating.
For deeper wear, see sanding and refinishing. For cleaning, see deep cleaning and maintenance, and for sealing, protective sealing.
Pricing Guide
Polishing is priced per square metre.
From AED 15*/m²
Lacquered floors.
From AED 15*/m²
Oiled floors.
From AED 5*/m²
If needed.
From AED 300*
Small areas.
*Prices shown are starting guides only. They vary and can change depending on your requirements, the size of the job, the surface, the materials and access to your building. You agree the final price before any work begins.
Tools and Materials
Abrade the finish gently. Good bond. Low dust.
Fresh protective coat. Shine restored. Durable.
Refreshes oiled floors. Natural look. Easy.
Clears sticky build-up. Clean base. Better finish.
Based in Al Barsha since 2014, we work across every Dubai community with trade-specialist technicians and a workmanship guarantee on every job.
Refresh without dust and days of work. Convenient. Value.
Recoat before wear-through. Floors last longer. Smart.
Hours, not days. Rooms back in use. Easy.
We tell you if sanding is needed instead. Fair. Clear.
A maintenance polish of an average room takes a few hours. Full sanding and refinishing of an apartment usually takes two to four days, including drying time between coats.
In busy Dubai homes, a maintenance polish or recoat every 12 to 24 months keeps the finish protected. Full sanding is only needed when the finish is worn through to bare wood.
Yes. Full restoration includes sanding back to clean timber, filling, staining if wanted and sealing. Light refreshes can use a screen and recoat without full sanding.
Parquet repair visits start from AED 300. Sanding and refinishing starts from about AED 35 per square metre, and new parquet installation from about AED 150 per square metre supplied and fitted. Prices vary and can change depending on your exact requirements, the materials and access to the property, so the final price is confirmed after we see photos or visit.
Areas We Cover
We polish parquet floors across Dubai.
Send photos and we will check if a polish is enough.